Space Ray LTS Series Two Stage - Manual (Page 26)

Form #43155040
May 2013
-25-
6.
Fasten reflectors to all of the tube support/hanger brackets as marked per (DETAIL–A) with (2) #10 sheet
metal screws. Note: Note: Note: Note: One reflector joint must not not not not be fastened to the tube support/hanger bracket in order
to slide during expansion of the heater.
7. Mount the sliding reflector clamps (#42769010) per Reflector Clamp Installation (DETAIL-B) on all tube
support/hanger brackets. Make sure the reflectors can slide under the clamp during heater operation.
The reflector clamps MUST be installed per reflector The reflector clamps MUST be installed per reflector The reflector clamps MUST be installed per reflector The reflector clamps MUST be installed per reflector
clamp installa
clamp installa clamp installa clamp installation detail which allows the reflector to tion detail which allows the reflector to tion detail which allows the reflector to tion detail which allows the reflector to
slide under the clamp during heater operation. slide under the clamp during heater operation. slide under the clamp during heater operation. slide under the clamp during heater operation.
Tube Support &
Hanger Bracket
Reflector
Clamp
Reflector
Clamp
Screw
REFLECTOR CLAMP INSTALLATION
DETAIL - B
Fasten screws to tube support/hanger
bracket and reflector.
#10 x 1/2” SHEET METAL SCREWS
(QTY - 2)
DETAIL - A
REFLECTOR
OVERLAP
(offset from tube
support/hanger brackets)
CORRECT INSTALLATION
Tube
Support/Hanger
Brackets
REFLECTOR
OVERLAP
(positioned over tube
support/hanger brackets)
INCORRECT INSTALLATION
3”
(control box to reflector)
2” overlap
1” overlap
1” overlap
The reflector overlap
must be able to slide at
this joint for expansion
of the heater.
CONTROL
BOX
DRAFT
INDUCER
DETAIL - A & B
DETAIL - B
DETAIL - A & B
DETAIL - A & B
DETAIL - A & B
40 FT SYSTEM SHOWN
DETAIL - B
DETAIL - B
DETAIL - B