Airaid 250-927 - Manual

Installation Instructions
Part Number 250-927
2010-2011 Magnacharged Camaro
With Airaid Intake system
2. Transfer the Mass Air Flow sensor from
the Plastic Intake Tube , into the aluminum
meter socket in the Carbon Fiber Tube and
secure by reusing the two 8-32 x 3/8
Screws.
3. Install the 3/8” Grommet and the Barbed
Fitting into the small hole in the Intake Tube
as shown.
Packing List:
KIT227T Carbon Fiber Intake Tube 1
K IT250927HP Hardware & Instructions 1
KITGRMT18 3/8” Grommet x1
KITFITTING23 Barbed PCV Fitting x1
KIT110T Zip Tie x3
Tools Required For Installation:
3/32” Allen Wrench
8, mm Socket, Ratchet & Extension, Pliers, and
Wire cutters
Installation Note: This kit is intended to replace
the existing Intake tube on vehicles already mod-
ified and using the Airaid intake and Mag-
nagcharger.
Technical Note. A New, vehicle specific Com-
puter Tune is required to successfully com-
plete this modification.
Disconnect The Negative Battery Termi-
nal!
1. Disconnect the breather line from the in-
take tube and unplug the Mass Air Flow
Sensor. Loosen the hose clamps and remove
the Intake tube.
Custom Shop