Airaid 1021 - Manual

Parts List
#1 ECONOAID x1
#2 Gasket x1
1. A.) Carefully lift straight up on the engine beauty cover and
remove it from the engine. (It is only held on by grommets.)
B.) Unsnap two clips and remove the plastic battery cover.
C.) Remove one plastic screw, and then remove the plastic
fresh air duct (D) from the vehicle.
2. A.) Loosen the hose clamp that secures the air intake tube to
the throttlebody. B.) Disconnect the crankcase breather from
the air intake tube. C.) Disconnect the mass air sensor wiring
connector from the mass air sensor on the air intake tube.
D.) Unlatch the four clips (one on each corner) that secure the
air cleaner lid to the lower airbox. Remove the air cleaner lid
and flexible air intake tube from the vehicle as an assembly.
Now remove the air cleaner from the lower airbox.
Thank you for purchasing the ECONOAID Throttlebody Booster. Please read the instruction manual carefully before pro-
ceeding with the installation. Contact ECONOAID @ (888) 876-4676 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit
or instructions that are not clear to you. Your ECONOAID Throttlebody Booster was carefully inspected and packaged. Check that
no parts are missing, or were damaged during shipping. If any parts are missing, please contact ECONOAID.
Part Number 1021
2003-09 Mazda3 2.0L & 2.3L (nonturbo)
2003-08 Mazda6 2.0L & 2.3L (nonturbo)
2006-09 Mazda5 2.3L
2008-10* Ford Focus 2.0L
2006-09 Ford Fusion/Mercury Milan 2.3L
*2010 model is not CARB legal
D
A
B
C
Tools Required For Installation
8mm, 10mm Sockets
Ratchet and Extension
Phillips Screwdriver
A
B
C
D
U.S. Pat. #7,665,442