Airmar U200 NMEA 2000® USB Gateway User Manual

Installation instructions, U200 gateway, Nmea 2000

Advertising
background image

Applications

The Gateway allows information to be displayed on a PC by
converting data from NMEA 2000® CAN to USB format.

Baud Rate

115,000

Tools & Materials

Safety goggles
Dust mask
Pencil
Electric drill
Drill bit: 3mm or 1/8"
Phillips screwdriver
Cable ties (some installations)

Cable Routing & Connecting Guidelines

CAUTION: To reduce electrical interference from other electrical
wiring and any on-board equipment with strong magnetic fields such
as radar equipment, radio transmitters, engines, generators, etc.,
separate the cables by at least 1m (3'). Ensure that all the cable
shields are appropriately grounded.

CAUTION: Do not remove the waterproof connector(s) to ease
cable routing. Removing the waterproof connector will void the
Gateway’s warranty.

CAUTION: Be careful not to tear the cable jackets when passing
them through compartments, bulkheads, or walls. Use grommets
to prevent chaffing.

CAUTION: Coil any excess cable(s) and secure with cable ties to
prevent damage.

* NMEA 2000® is a registered trademark of the National Marine

Electronics Association.

* WeatherStation® and WeatherCaster™ are registered trademarks of

Airmar Technology Corporation.

INSTALLATION INSTRUCTIONS

Follow the safety precautions below to reduce

the risk of poor product performance, property

damage, personal injury, and/or death.

WARNING: Always wear safety goggles and a dust

mask when installing.

WARNING: The power supply must be OFF before

making electrical connections.

WARNING: The Gateway is powered by the USB

connection at 5 V.

WARNING: A safe installation requires a 0.5 amp fast-

blow fuse or circuit breaker. Except WeatherStation

®

models with a heater require a 3 amp fast-blow fuse or

circuit breaker.

WARNING: The power source must be isolated from

the engine start battery(s). Voltage drops may cause

the instrument/receiver/sensor to lose information

and/or change operating mode.

IMPORTANT: Please read the instructions completely

before proceeding with the installation. These

instructions supersede any other instructions in your

instrument manual if they differ.

NMEA 2000

®

to

USB

U200 Gateway

For WeatherStation

®

Instrument

GPS Receiver

Heading Sensor

17

-4

93

-0

1 re

v.

06

10

/03

/11

Advertising
This manual is related to the following products: