Cascade Microtech Pyramid Probes - Manual

PN 153-690-3 www.cascademicrotech.com Pyramid Probes: New Core Inspection • 1
This guide describes the visual inspection process for new Pyramid Probe cores. Visual inspection should be performed
first visually, and then with a microscope. The recommended procedure employs two microscopes:
When saving photos, be sure to include the serial number in the file name.
Use the Pyramid Probes Certificate of Conformance to verify the following:
• The serial number on the core frame matches the Pyramid Probes Certificate of Conformance.
• The product name on the Pyramid Probes Certificate of Conformance matches the product to be tested.
For a more detailed description of documents shipped with a new core, see the Pyramid Probe Core User Manual.
Step1: Edge Sense Inspection
Pyramid Probes used on manual probe stations have an edge sense type mechanical switch installed. The edge sense
needle contacts a glass pad on the spring in some Pyramid Probes. When installed on larger frame cores, the edge sense
needle contacts the core spring directly. This step applies only to manual probe stations.
Low-magnification microscope
(with a large working space)
High-magnification microscopes
• Commonly used for PCB inspection and
soldering stations
• Used for inspecting the entire probe, core
window, components and membrane wing
• Magnification range should be approximately
7x to 90x
• Used for inspecting the probe face, probe tips
and beams
• Recommended microscope objectives include
5x, 20x, and 50x
Inspection Area Criteria
Edge Sense
(if glass pad is
installed)
Are there cracks in the glass pad?
Contact local support for instructions.
Is the glass pad securely in place?
Contact local support for instructions.
Is the needle touching the glass pad, and roughly centered?
Contact local support for instructions.
Quick Reference Guide
Pyramid Probes: New Core Inspection