H3C Technologies H3C S12500 Series Switches - Manual

1
H3C SFP/SFP+/XFP Transceiver
Modules Installation Guide
(CH&EN,V1.08)
BOM: 3105A00Y
IMPORTANT:
•
Carefully read this guide before installing a transceiver module.
• The descriptions in first four sections in this guide are applicable
to all SFP, SFP+, and XFP transceiver modules provided by H3C
and the descriptions in the last section are applicable to SFP+
transceiver modules and SFP+ DAC/AOC cables.
Support for transceiver modules depends on the device model. For more
information, see the installation guide.
Wearing an ESD wrist strap
Be sure to wear an ESD wrist strap when installing or removing a
transceiver module.
Make sure the wrist strap makes good skin contact and attach the wrist
strap wire to the ESD jack (if any) on the device chassis as shown in the
left part of
Figure 1 , or to the rack with an alligator clip as shown in the
right part of Figure 1 .
If you also use ESD gloves, wear the wrist strap outside an ESD glove
and ensure that it has good contact with the glove.