H3C Technologies H3C S10500 Series Switches - Manual (Page 108)

100
Figure 59 Removing the grounding cable
(1) Grounding sign (2) Remove the grounding cable from the chassis
(3) Loosen the hex nut on the grounding post of the grounding strip
Removing the twisted pair and optical fiber
You must remove twisted pairs and optical fibers from all the interfaces of the switch.
NOTE:
After pulling out an optical fiber from an optical transceiver module, cover the connector of the optical
fiber with a dust cap to keep the connector clean.
Repackaging the switch accessories
Repackaging the power module
CAUTION:
Before removing a power module, switch off the circuit breakers at the input end of all power cables, and
remove all the power cables to avoid device damage and bodily injury.
To repackage a power module:
1. Prepare the packing bag and box of the power module. Make sure the bag is clean, dry, and not
damaged.
2. Remove all power modules from the chassis, and then install blank filler panels to the empty slots.
For how to remove a power module and install a blank filler panel, see "
Replacement
procedures ."
3. Put the power module into the bag.
4. Put the packed power module and power cable into the box. Place the power module in a correct
direction onto the foam cushion in the box; otherwise, the power module cannot be completely
seated into the foam cushion.