H3C Technologies H3C S10500 Series Switches - Manual (Page 111)

103
Figure 61 Removing the mounting brackets from the chassis (S10508)
3. Put the mounting brackets into the box.
Removing the cable management brackets
The S10508-V has two cable management brackets—the one on the chassis bottom routes power cables,
and the one on the chassis top routes signal cables.
The S10504, S10508, and S10512 provide a cable management bracket at the chassis bottom to route
power cables. The procedure for removing the cable management bracket is similar to that of the
S10508-V.
To remove the cable management brackets:
1. Prepare the packing bag of the cable management brackets. Make sure the bag is clean, dry, and
not damaged.
2. Use a Phillips screwdriver to loosen the screws that attach the cable management brackets to the
chassis, and then remove the cable management brackets.
3. Put the cable management brackets into the bag.