Installing frus, Attaching an esd wrist strap – H3C Technologies H3C S10500 Series Switches User Manual

Page 29

Advertising
background image

21

Installing FRUs

There is no required order for installing FRUs. H3C recommends that you connect power cords after

completing installing all required FRUs.

TIP:

Keep the chassis and the component packages for future use.

Attaching an ESD wrist strap

Every S10500 switch provides an ESD wrist strap. To minimize ESD damage to electronic components,

wear the ESD wrist strap and make sure it is well grounded when installing modules.
To use an ESD wrist strap:

1.

Make sure the switch is well grounded. For how to ground your switch, see "

Installing the switch

."

2.

Put on the wrist strap.

3.

Tighten the wrist strap to keep good skin contact. Make sure the resistance reading between your
body and the ground is between 1 and 10 megohms.

4.

As shown in

Figure 18

, insert the ESD wrist strap into the ESD port on the switch chassis, or attach

it to the grounding screw of the chassis with an alligator clip.

Figure 18 Attaching an ESD wrist strap (on an S10508)

(1) ESD wrist strap port (having an ESD sign)

Advertising
This manual is related to the following products: