H3C Technologies H3C S10500 Series Switches - Manual (Page 78)

70
NOTE:
•
The XXXSE3 LPUs, such as LSU1GP48SE3 and LSU1GT48SE3, are only available for the S10500
switches that run the Comware V5 software.
• LSU1CGC2SE0 is only available for the S10500 switches that run the Comware V7 software.
• A combo interface is a logical port that contains an SFP interface and an RJ-45 Ethernet interface. Only
one of them can be activated at a time.
• The LSU1TGS48SF0 does not support the SFP-XG-LX220-MM1310 module and the LSTM2STK cable.
Switching fabric modules
CAUTION:
•
Do not install B-type switching fabric modules (LSU1FAB04B0, LSU1FAB08B0, and LSU1FAB12B0) and
D-type switching fabric modules (LSU1FAB04D0, LSU1FAB08D0, and LSU1FAB12D0) on the same
switch.
• A-type and B-type switching fabric modules for the S10504 and S10508 switches can be used in the
same chassis, but the performance of B-type modules will be reduced to match the performance of
A-type's.
• The switching fabric modules for S10500 switches provide a console port for the H3C technical support
staff to maintain the switches. Do not use the console port if you have not been trained for that.
You can install up to four switching fabric modules in one S10500 switch chassis.
Table 20 Switching fabric module ordering guide
Chassis model Available switching fabric module model
S10504
LSU1FAB04A0 (LSUM1FAB04A0)
LSU1FAB04B0 (LSUM1FAB04B0)
LSU1FAB04D0 (LSUM1FAB04D0)
S10508 LSU1FAB08A0 (LSUM1FAB08A0)
LSU1FAB08B0 (LSUM1FAB08B0)
LSU1FAB08D0 (LSUM1FAB08D0)
S10508-V
S10512
LSU1FAB12B0 (LSUM1FAB12B0)
LSU1FAB12D0 (LSUM1FAB12D0)
Power modules
The switch supports power modules of models LSUM2AC2500 and LSUM1DC2400. An
LSUM2AC2500 power module is an AC-input, DC-output power module that provides a maximum DC
output power of 2500 W. An LSUM1DC2400 power module is an DC-input, DC-output power module
that provides a maximum DC output power of 2400 W.