Extreme Networks BlackDiamond 12804 - Manual (Page 109)

BlackDiamond Series Blank Front Panels
BlackDiamond 12800 Series Switches Hardware Installation Guide 109
Figure 69: Blank Front Panels in BlackDiamond Series Chassis
3 Use a #2 Phillips screwdriver to tighten the captive screws at each end of the blank front panel.
NOTE
Tighten the screws of each installed blank front panel before inserting additional modules or blank front panels.
Otherwise, you might unseat modules or blank front panels that you have not secured.
NOTE
Leave the ESD-preventive wrist strap permanently connected to the chassis so that it is always available when you
need to touch ESD-sensitive components.
Removing a Blank Front Panel
To remove a BlackDiamond blank front panel:
1 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the switch front panel.
On a BlackDiamond 12804 series chassis, the ground receptacle is at the top left corner.
On a BlackDiamond 12802 chassis, the ground receptacle is at the top right corner.
2 Loosen the captive screw at each end of the blank front panel, using a #2 Phillips screwdriver (see
Figure 70 ).
ASP018