Emerson SiteLink-4 User Manual

Emerson Hardware

Advertising
background image

Specification for SiteLink-4


DESCRIPTION:
The SiteLink-4 is a 32 bit microprocessor-based communications device that provides
an interface for up to four Liebert Unit Controllers (IGM’s). The SiteLink-4 communicates to either the
SiteScan Monitoring System, or a third party software program utilizing a designated open standard
protocol (i.e. Modbus or BACnet). This device communicates to the SiteScan Monitoring System via a
twisted pair called the ARC156 network through an EIA-485 port at either 156K / 9600 or 38.4kbps baud.
It communicates to the third party software monitoring system via a 9-pin DTE male EIA-232 connector
(Portal Interface) or at the 5 pin EIA485 port communicating at either 9600bps or 38.4kbps baud. Four
EIA-422 ports are provided to connect Liebert Information Gathering Modules.

DIMENSIONS:

Module:

7 1/2" H x 11 1/4" W

19.05cm H x 28.58cm W


Enclosure:

12”H x 14.25" W x 2.85" D

(painted steel)

419.1mm x 301.3mm x 78.6mm


See Enclosure Diagrams for mounting options.



POWER:

24VAC

± 10%, 50-60 Hz., 7.2VA power consumption (120/24VAC 40VA

transformer available).


ENVIRONMENTAL
OPERATING RANGE:
0

° to 130° F (-17.8° to 54.4° C), 10 to 90% relative humidity, non-condensing


COMMUNICATION:

CMnet EIA-485 Port - Control Module network screw terminals

Switch selectable baud rates ARC156 / 9600 or 38.4bps
Recommended wire is: MAGNUM Cable pn A3-ARC-156-2

Two (2) Portal Interface – One EIA-232, One EIA-485 2 / 4 wire (for Third Party
software selectable baud rate, 9600bps or 38.4kbps

One (1) Access port (for diagnostics)

Four (4) EIA-422 Ports (for Liebert unit connection) - screw terminal


MEMORY:

1024 kB Flash memory and 1024 kB non-volatile battery-backed RAM.


PROTECTION:

Voltage, current, and ESD protection on incoming power and CMnet.

Liebert Corporation

Page 1 of 5 SL-27213 Rev. 4; 7/03

Advertising