Setting up the printer, Connecting the cable – Epson 440 EN User Manual
Page 20
15
7
Close the Add/Remove Programs Properties window, close the Control
Panel, and then shut down the computer.
Setting Up the Printer
If you’ve been using your EPSON printer with your computer, the printer is
probably set up already. If so, make sure your system is turned off and
disconnect the printer from the computer. Also, make sure the printer
software has been deleted, as described above. Then go to “Connecting the
Cable” in the next section to attach the cable to your system.
If you’re setting up a new printer, see the documentation that came with your
printer for instructions on unpacking it, installing ink cartridges, and loading
paper. Then return to this booklet for instructions on connecting the cable
and installing your printer software.
Connecting the Cable
You can connect the USB/Parallel Adapter directly to a USB port on your
computer, or you can connect it to a USB hub connected to a port on your
computer. If you have any printing problems when the printer is connected
via a USB hub, try connecting your printer directly to the USB port on the
computer instead.
usb4.book Page 15 Wednesday, October 6, 1999 2:07 PM