Curtis SKCR2613C - Manual

Under Cabinet CD
Clock Radio with
Remote
MODEL SKCR2613C
READ THIS INSTRUCTION MANUAL BEFORE
CONNECTING OR OPERATING THIS
APPLIANCE. SAVE THIS INSTRUCTION
MANUAL FOR FUTURE REFERENCE.
LOCATION OF THE CONTROLS
MAIN UNIT
REMOTE CONTROL
INFORMATION:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or modifications to
this equipment may cause harmful interference unless the modifications are expressly
approved in the instruction manual. The user could lose the authority to operate this equipment
if an unauthorized change or modification is made.
Before using the unit, be sure to read all operating instructions carefully. Please note that
these are general precautions and may not pertain to your unit. For example, this unit may
not have the capability to be connected to an outdoor antenna.
1. Read these instructions.
All the safety and operating instructions should be read before the product is operated.
2. Keep these instructions.
The safety and operating instructions should be retained for future reference.
3. Heed all warnings.
All warnings on the product and in the operating instructions should be adhered to.
4. Follow all instructions.
All operating and use instructions should be followed.
5. Do not use this apparatus near water.
Do not use this product near water and moisture, for example: near a bathtub, washbowl,
kitchen sink or laundry tub; in a wet basement; or near a swimming pool.
6. Clean only with dry cloth.
Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or
aerosol cleaners. Use a dry cloth for cleaning.
7. Do not block any ventilation openings. Install in accordance with the manufacturer's
instructions.
Slots and openings in the cabinet and in the back or bottom are provided for ventilation, to
ensure reliable operation of the product and to protect it from overheating. These openings
must not be blocked or covered. The openings should never be blocked by placing the
product on a bed, sofa, rug or other similar surface. This product should never be placed
near or over a radiator or heat source. This product should not be placed in a built-in
installation such as a bookcase or rack unless proper ventilation is provided or the
manufacturer's instructions have been adhered to.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide blade or the third prong are
provided for your safety. If the provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold
with the apparatus. When a cart is used, use
caution when moving the cart/ apparatus
combination to avoid injury from tip-over
An appliance and cart combination should be moved
with care. Quick stops, excessive force and uneven
surfaces may cause the appliance and cart combination to overturn.
13. Unplug this apparatus during lightning storms or when unused for long periods of
time. To protect your product from a lightning storm, or when it is left unattended and
unused for long periods of time, unplug it from the wall outlet and disconnect the antenna
or cable system. This will prevent damage to the product due to lightning and power-line
surges.
14. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture does not operate normally, or has
been dropped.
15. Power source.
This product should be operated only from the type of power source indicated on the
marking label. If you are not sure of the type of power supply to your home, consult your
appliance dealer or local power company. For products intended to operate from battery
power, or other source, refer to the operation instructions.
16. Power lines.
An outside antenna system should not be located in the vicinity of overhead power lines or
other electric light or power circuits, or where it can fall into such power lines or circuits.
When installing an outside antenna system, extreme care should be taken to keep from
touching such power lines or circuits as contact with them might be fatal.
17. Overloading.
Do not overload wall outlets and extension cords as this can result in a risk of fire or
electric shock.
PORTABLE CART WARNING
(symbol provided by RETAC)
ANTENNA LEAD IN WIRE
ANTENNA DISCHARGE
UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTOR
(NEC SECTION 810-21)
GROUND CLAMPS
GROUND CLAMP
ELECTRIC SERVICE
EQUIPMENT
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
SAFETY INSTRUCTION
CAUTION
RIKS OF ELECTRIC
SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO
USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
LASER SAFETY: This unit employs a laser. Only qualified service personnel should
attempt to service this device due to possible eye injury.
CAUTION: USE OF CONTROLS, ADJUSTMENTS OR PERFORMANCE
PROCEDURE HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
SURGE PROTECTORS:
It is recommended to use a surge protector for AC connection.
Lightning and power surges ARE NOT covered under warranty for this product.
DANGEROUS VOLTAGE:
The lightning flash with arrowhead symbol, within an
equilateral triangle is intended to alert the user to the
presence of uninsulated dangerous voltage within the
product’s enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
ATTENTION:
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
DANGER:
Invisible and hazardous laser radiation when open and
interlock failed or defeated. Avoid direct exposure to
beam.
18. Object and liquid entry.
Never push objects of any kind into this product through openings as they may touch
dangerous voltage points or short out parts that could result in fire or electric shock.
Never spill or spray any type of liquid on the product.
19. Outdoor antenna grounding.
If an outside antenna is connected to the product, be sure the antenna system is grounded
so as to provide some protection against voltage surges and built up static charges. Section
810 of the National Electric Code ANSI/NFPA 70 provides information with respect to
proper to grounding of the mast and supporting structure, grounding of the lead-in wire to
an antenna discharge product, size of grounding conductors, location of antenna-discharge
product, connection to grounding electrodes and requirements for the grounding
electrodes.
20. Service.
Do not attempt to service this product
yourself as opening or removing covers
may expose you to dangerous voltage
or other hazards. Refer all servicing to
qualified service personnel.
21. Replacement parts.
When replacement parts are required, be
sure the service technician uses replacement
parts specified by the manufacturer or those that have the same characteristics as the
original parts. Unauthorized substitutions may result in fire or electric shock or other
hazards.
22. Safety check.
Upon completion of any service or repairs to this product, ask the service technician to
perform safety checks to determine that the product is in proper operation condition.
23. Wall or ceiling mounting.
The product should be mounted to a wall or ceiling only as recommended by the
manufacturer.
24. Damage requiring service.
Unplug this product from the wall outlet and refer service to qualified service personnel
under the following conditions.
a) When the power-supply cord or plug is damaged.
b) If liquid has been spilled or objects have fallen into the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the operating instructions.
Adjust only those controls that are covered by the operating instructions, as an
adjustment of other controls may result in damage and will and require extensive work
by a qualified technician to restore in the product to its normal operation.
e) If the product has been dropped or the cabinet has been damaged.
f) When the product exhibits a distinct change in performance- this indicates a need for
service.
25. Note to CATV system installer.
This reminder is provided to call the CATV system installer's attention to Article 820-40
of the NEC that provides guidelines for proper grounding and, in particular, specifies that
the cable ground shall be connected to the grounding system of the building, as close to
the point of cable entry as practical.
WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
• The remote control supplied with this product contains a button cell battery. If the button
cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to
death.
• Keep new and used batteries away from children. If the battery compartment does not close
securely, stop using the product and keep it away from children.
• If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention.
Sylvania SKCR2613C (Eng) R2 • 18/3/2014 • AT
Tools required
• Drill and 1/4” drill bit
• Ruler or tape measure
• Nail
• Scissors
• Phillips head screwdriver
• Masking tape
• Safety glasses Included
• 3x Spacers
• 3 x Washers
• 3x Screws
• Mounting template
Cabinet Mounting
1
2
3
4 5 6 7 21 16 1011 12 14
13
15
9
17
18
22
19
20
1
3
5
7
6
9
11
10
13
4
2
14
15
16
8
17
18
12
1 Standby Button
2 Function Button
3 Alarm 1 button
4 Vol- (Volume decrease) button
5 Vol+(Volume increase) button
6 Alarm 2 / Mute button
7 M- button
8 M+ button
9 Open/Close button
10 PROG (Program)/ (Time Set) button
11 Repeat / Random button 12 Backward button
13 Stop button
14 Forward button
15 Play/Pause button
16 LCD Display
17 AUX in Jack
18 Headphone Jack
19 Power Cord Line
20 Hanging Hole
21 Remote Sensor
22 Battery Compartment (clock backup)
1 STAND BY Button
2 MEM / PROG (Memory/Program) button
3 Stop Button
4 Vol+(Volume increase) button
5 Backward Button
6 Play/Pause Button
7 M+ Button
8 Vol- (Volume decrease) button
9 M- Button
10 Function Button
11 Time Set Button
12 Snooze Button
13 Mute Button
14 Repeat Button
15 Forward Button
16 AL.SET (Alarm Set) button
17 Open/Close button
18 Sleep Button
INSTRUCTION MANUAL
445 x 191 mm
1
2