Curtis SCR1414 - Manual

LED ALARM CLOCK RADIO
LOCATION OF CONTROLS
1. Speaker
2. Power Cord
3. Function Switch
4. Minute Button
5. Hour Button
6. Sleep Button
7. Snooze Button
8. Time Setting
9. Alarm Setting
10. Battery Compartment
11. AM/FM Band Switch
12. Volume Control
13. FM Antenna
14. Tuning Control
15. LED Display
16. Tuning Scale
17.Hi-low Dimmer
POWER SUPPLY
Check the AC current is same as the instruction show on rating label of your unit and plugs the power cord
into the AC outlet. A blinking signal will appear indicating the time.
LISTEN TO THE RADIO
Slide the Function Switch to ON position and rotate the Volume Control to turn on the radio. Adjust the
Volume Control to the desired listening level and select your favorite station with the Tuning Control and
Band Selector. To turn off the radio, slide the Function Switch to OFF position.
Loose the cable antenna for FM and adjust the direction to get the best reception if the radio could not
get a clear station.
TIME SETTING
Press and hold the Time Set Button and then press the Hour or Minute Button for hour and minute
adjustment of the time. Please make sure setting time is AM or PM has indication (A dot will light in the
left upper corner indicating that the time is the PM range if your unit is 12 hour version type.)
WAKE TO MUSIC
Press and hold the Alarm Set Button and then press Hour or Minute button to set the desired wake up time.
Release the Alarm Set Button to show the current time. Repeat the steps of “LISTEN TO RADIO” to your
desired station and listening level. Slide the Function Switch to AUTO position. The Alarm Indicator will on.
The radio will play your desired station and listening level automatically at the preset alarm time. Push the
Function Switch to OFF position to turn off the radio alarm.
WAKE TO BUZZER
Same operation as “WAKE TO MUSIC” to adjust the alarm time, and then rotate the Volume Control
clockwise until a clicking sound is heard. Your will be awakened by the buzzer alarm.
Push the Function Switch to OFF position to turn off the buzzer alarm.
SNOOZE FUNCTION
When you want a few extra minutes of sleep after the alarm wakes you, press the Snooze Button, the
music or buzzer alarm will be off and turn on again in approximately 9 minute. Push the Function Switch
to OFF to turn off the snooze function.
SLEEP TO MUSIC
1.Slide the Function Switch to the position either OFF or AUTO. Press the Sleep Button once and you
will have 59 minutes listen to the radio (the default setting).
2.If you want to increase or reduce the automatic shut off time, hold down the Sleep button and press Hour
or Minute to adjust as required. The maximum sleep time is 1 hour and 59 minutes.
TO GO TO SLEEP AND WAKE TO MUSIC
Repeat the steps of “WAKE TO MUSIC”, press Sleep Button to set for desired time of radio playing before
sleep. The radio will stop as your setting of sleep time automatically and will play again at your preset
wake up time.
BATTERY BACKUP
Insert a 9 Volt battery in the battery compartment. Should there be a power failure, the clock will continue
to function. Your will not see this however because the battery does not illuminate the clock display. When
the electric power turns on again, the display will indicate the correct time. For clarity alarm clock does not
work on battery. Replace the battery once a year.
WARNINGS
-The ventilation should not be impeded by covering the ventilation openings with items, such as
newspapers, table-cloths, curtains, etc;
-No naked flame sources, such as lighted candles, should be placed on the apparatus;
-It shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases,
shall be placed on the apparatus;
-Do not place the product in closed bookcases or racks without proper ventilation.
-Where the mains plug is used as the disconnect device, the disconnect device shall remain readily
operable.
SCR1414
15
14
12 11 9 8 7 6 5 4 3
16
13
10
2
1 17
SCR1414