Elite B/W User Manual
Disconnect power to the unit, While maintaining pressure, turn the key clockwise, Open the cover
#
#
#
1
2
3
4
5
6
7
8
9
0
*
#
#
?
#
I N S T A L L A T I O N F O R E L 2 0 0 0
C A M E R A M O D U L E M O D E L S E L 2 0 0 0 B W C A M K T ,
E L 2 0 0 0 C C A M K T A N D E L 2 0 0 0 D V R C A M K T
B L A C K / W H I T E , C O L O R
& L O W L U X C O L O R
C A M E R A M O D U L E S
F O R T H E E L 2 5 & E L 2 0 0 0 T E L E P H O N E
E N T R Y A C C E S S C O N T R O L S Y S T E M S
#
#
1
2
3
?
4
5
6
7
8
9
*
0
#
#
#
#
#
#
#
1
2
3
?
4
5
6
7
8
9
*
0
#
#
#
#
#
#
2
3
1
Disconnect power to the unit.
2
To open, apply pressure to the right-side of the unit.
3
While maintaining pressure, turn the key clockwise.
4
Open the cover.
5
To remove the LED board, unplug the wire harness from LED
board and remove the screws (3). Do not remove the rubber
O-ring.
6
Replace black plastic lens with the clear lens. Keep rubber
O-ring in place.
7
Install the camera module. Reconnect the LED board wire
harness to the camera module.
8
Feed a coaxial cable (not provided) through the conduit hole
in the back mounting plate of the unit. Connect a BNC coaxial
connector to the back of the camera module.
9
Close and lock the unit.
10
Reconnect power to the unit.
NOTE:
If the EL2000 is connected to a home entertainment system,
the home entertainment system must be switched to video input.
4
5
7
8
6
Clear Plastic Lens
Camera Module
Wire Harness
LED Board
O-ring
BNC Coaxial Connector
A static discharge can damage circuit boards.