Eagle Electronics CUDA 350 S/MAP - Manual (Page 165)

157
Recommended Tools and supplies
Recommended tools for this job include: wire pliers or wire stripper and a
wire cutter. Required supplies for this job include: two gray (18 gauge) or
blue (16 gauge) wire nuts and electrical tape. Supplies are not included.
Wiring Diagram "A"
Begin by stripping the wire ends of the device you're connecting to the Cuda
350. (You'll notice the Cuda 350 data cable comes pre-stripped, with wire
ends exposed.) Use a pair of wire pliers to strip about 1/4-inch (6.35 mm) of
insulation from each of the radio's or other device's data wires.
Strip the ends of the VHF radio's data wires. Connect them to the pre-
stripped wires of the Cuda 250 data cable (shown right).
Twist the exposed wires together as shown in the following figures. If
you're using a Uniden or similar radio, connect the radio's NMEA Wire
to the Cuda 350 data cable's yellow wire, and the radio's Ground/Shield
wire to the Cuda 350 data cable's black shield wire. If you're using an-
other radio brand or NMEA device, see Wiring Diagram B instructions
on page 161.