Epson Stylus CX3200 - Manual (Page 6)

(3621 6W\OXV &;
  (3621 6W\OXV &; 
Placing Your Original Document
Place your document face-down on the glass, in the corner
shown below. Move your document about 0.1 inch from the
top and side edge so your entire document is scanned.
Note:
If you place your document against the guides, the edges next to the
guides won’t be scanned.
If you need to scan a thick document, such as a book, you can
remove the scanner lid to scan. Gently press down the original to
keep it flat on the document table. Be sure to replace the scanner lid
when you’re finished.
Stand-Alone Copying
Basic Copying
1. Place your document face-down on the glass, as shown to
the left.
2. The default copy settings are displayed on the control panel.
Change any necessary copy settings, as described in
“Changing Copy Settings” below.
3. Press the Color Copy button (for color copies) or B&W
Copy button (for black and white copies). Your document
is scanned and then printed. If you’re using the 2-up Copy
Mode setting (see “Type of Copies” on page 7), repeat these
steps for your second page.
Note:
Your copied image size may not be the exact same size as your
original.
Changing Copy Settings
The current copy settings are shown on the LCD screen. You
can change copy settings using the control panel, as described
below.
When you finish changing a setting, press the Stop button.
Note:
To clear a setting, press the Reset button. To clear all the setting
changes you’ve made, press and hold the Reset button for at least 3
seconds.
If you’ll be changing the Copy mode setting (as described in “Type of
Copies” on page 7), select your Copy mode before selecting any
other copy settings.
Number of Copies
Press the + or - Copies buttons. (If you’re using the 2-up Copy
Mode setting (see “Type of Copies” below), you can’t select the
number of copies.)
Paper Size
Press a Menu button until you see Paper size on the LCD
screen. Then press the + or - Value buttons to select the size of
the paper you loaded, either Letter , 4 Ч 6 , 5 Ч 7 , or A4
(8.3 × 11.7 inches).
Lighten or Darken
Press a Menu button until you see Lighter/Darker on the LCD
screen. Then press the + or - Value buttons to lighten or darken
your copies.
Move the
document in
about 0.1 inch
from the edges
Current settings are shown here
Menu
buttons Copies/Value
buttons (+ and -) Stop
button Reset
button