Kichler 41055 - Manual

1) Align holes in support bracket with holes on
back of mirror.
2) Thread screw through hole in support bracket
and mirror.
3) Slip bushing over screw protruding from front
of mirror.
4) Slip nylon washer then rubber washer over
screw protruding from front of mirror.
5) Set frame on top of mirror aligning holes in
back of frame with screws.
6) Thread screws in to holes in frame. Tighten
screws to secure frame in place.
7) Note position of support bracket inside back of
mirror.
8) Determine desired location of mirror on wall.
9) At position where support bracket will be, mark
position of top holes using the wall bracket as
a template.
10) Drill 3/8” (10mm) diameter holes in wall at marks.
11) Slip mounting screws through holes in wall
bracket and thread wings on to screws.
12) Compress wings and slip through holes drilled
in wall.
13) Tighten screws until wall bracket is secure
against wall.
14) Slip fixture over wall bracket until support
bracket lays in “J” of wall bracket.
BUSHING
RUBBER WASHER
NYLON WASHER
SCREW
SUPPORT BRACKET
SUPPORT BRACKET
FRAME
WING
MOUNTING SCREW
WOOD SCREW
WALL BRACKET
Date Issued: 2/8/13 IS-41055-BL