Kichler 78202 User Manual

Kichler For Home

Advertising
background image

1) Remove frame from mirror by removing two screws with

rubber washers on each side of frame. (Total of four screws

with rubber washers.)

2) On inside of frame remove screws in outlet box cover.

Remove outlet box cover from frame.

3) TURN OFF POWER.

IMPORTANT: Before you start, NEVER attempt any work

without shutting off the electricity until the work is done.

a) Go to the main fuse, or circuit breaker, box in your

home. Place the main power switch in the “OFF” position.

b) Unscrew the fuse(s), or switch “OFF” the circuit breaker

switch(s), that control the power to the fixture or room that

you are working on.

c) Place the wall switch in the “OFF” position. If the fixture

to be replaced has a switch or pull chain, place those in

the OFF” position.

4) Determine desired location for mirror on mounting surface.
5) Holding frame up against mounting surface at desired location,

mark the holes at each corner of frame on mounting surface,

making sure the mounting strap hole pattern aligns with the

junction box.

6) Drill holes in mounting surface at marks to accommodate

wall anchors.

7) Push wall anchors into holes and tap until flush with wall.
6) Place frame up against mounting surface.
8) Pull outlet box wires through hole in center of frame.
9) Align holes in each corner of mirror frame with holes in wall
anchors.
10) Thread mounting screws through holes near center of frame

that match up with holes in outlet box. Tighten mounting

screws.

NOTE: Make sure holes in each corner of frame remain

aligned with holes in wall anchors.

11) Thread screws into holes in mirror frame and into wall

anchors. Tighten screws to secure mirror frame to mounting

surface.
12) Wrap supply line ground wire around ground screw located

in center of frame.

13) Connect uninsulated fixture ground wire to outlet box ground

wire with wire connector. (Not provided.) After following the

above steps. Never connect ground wire to black or white

power supply wires.

14) Make wire connections (connectors not provided.) Reference

chart below for correct connections and wire accordingly.

15) Place outlet box cover over hole in center of frame. When in

place, round rubber plug on outlet box cover should be

located at the bottom of the cover. Wires should extend

from outlet box cover under round plug.

IMPORTANT: DO NOT push wires back into outlet box.

Wire connections should remain inside mirror frame.

(REF. FIG 3.)

16) Thread screws into holes in outlet box cover.
17) Raise mirror up to frame on mounting surface.
18) Fit two brackets on one side of back of mirror inside one

side of frame.

19) Push other side of mirror towards frame. Fit remaining two

brackets on back of mirror inside frame.

20) Thread one screw with rubber washer into each hole on

sides of frame. Carefully tighten screws to secure mirror to

frame.

FRAME

SCREW

Date Issued: 7/12/13

IS-78202-US

WALL ANCHOR

Connect Black or

Red Supply Wire to:

Connect

White Supply Wire to:

Black

White

*Parallel cord (round & smooth)

*Parallel cord (square & ridged)

Clear, Brown, Gold or Black

without tracer

Clear, Brown, Gold or Black

with tracer

Insulated wire (other than green)

with copper conductor

Insulated wire (other than green)

with silver conductor

*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)

Neutral Wire

MIRROR

FRAME

OUTLET BOX COVER

FRAME

1

2

3

OUTLET BOX COVER

4

Advertising