Sony ILCA-99M2 - Manual (Page 244)

Note
[WPS Push] works only if the security setting of your access point is set to WPA or WPA2 and your
access point supports the Wi-Fi Protected Setup (WPS) button method. If the security setting is set
to WEP or your access point does not support the Wi-Fi Protected Setup (WPS) button method,
perform [Access Point Set.].
For details about the available functions and settings of your access point, see the access point
operating instructions or contact the administrator of the access point.
A connection may not be enabled depending on the surrounding conditions, such as the type of wall
material or if there is an obstruction or poor wireless signal between the product and access point. If
that happens, change the location of the product or move the product closer to the access point.
[243] Using wireless functions Changing the wireless connection settings
Wi-Fi Settings: Access Point Set.
You can register your access point manually. Before starting the procedure, check the SSID
name of the access point, security system, and password. The password may be preset in
some devices. For details, see the access point operating instructions, or consult the access
point administrator.
Press the WPS button on the access point you want to register. 2
MENU
→
(Wireless)
→ [Wi-Fi Settings] → [Access Point Set.].
1
Select the access point you want to register.
When the desired access point is displayed on the screen: Select the desired access
point.
When the desired access point is not displayed on the screen: Select [Manual Setting]
and set the access point.
If you select [Manual Setting], input the SSID name of the access point, then select the
2