Through-desk mounting, P/2 da4xi and p/2 da6xi, cont’d – Extron electronic VGA Distribution Amplifiers P/2 DA6xi s User Manual
Page 8
P/2 DA4xi/6xi • User’s Guide
P/2 DA4xi and P/2 DA6xi, cont’d
Through-desk mounting
The P/2 DA4xi/6xi can be mounted using the optional
through-desk mounting brackets (Extron part #70-077-02).
1.
Attach the mounting brackets to the DA with the screws
provided (shown below).
2.
Mark the opening, 1.6" x 8.7" (4.1 cm x 22.1 cm), through
which the unit will be mounted.
3.
Cut the proper sized hole in the mounting surface.
4.
Hold the DA with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
5.
Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
6.
Insert four #8 wood screws through the bracket and into
the four pilot holes. Tighten all four screws to secure the
DA in place.
4