Sealey AK438 User Manual
Fig.8 fig.7, Fig.6, Safety instructions
3.1. CHANGING THE BULB
WARNING! Ensure the spotlight is turned off and the lens has cooled
prior to changing the bulb.
1. Remove the hood from the spotlight.
2. Carefully lift the hood and reflector assembly revealing the
spring clip (fig. 6.1.) and three wires.
3. Disconnect the three wires (fig. 6.2.). Make a note which wires
connect to which terminal.
4. Remove the spring clip (fig. 6.1.).
5. Pull bulb (fig.6.3) outward from the reflector.
6. Hold the new bulb with a lint free cloth, (do not handle the bulb),
and install by reversing the above procedure.
3.2. CHANGING THE BATTERY
WARNING! Ensure you read, understand and apply safety
instructions relating to the battery before changing.
1. Remove the rear rubber seal by way of the polymer knobs either
side (fig. 1B). Unscrew them counter clockwise.
2. Remove battery braces with phillips screwdriver.
3. Securely grip the exposed end of the battery and carefully slide it a
few inches out of the housing (fig. 8).
4. Disconnect the battery terminal wires. Remove the black negative
wire first.
WARNING! Beware of causing a short circuit.
5. Carefully remove the battery.
6. Replace with genuine Sealey battery and install by reversing the
above procedure.
Notes: a) Take care not to pinch or cross-connect any wires.
b) When replacing rear rubber seal make sure that
both knobs are secure.
7. Dispose of old batteries in accordance
with local authority lead-acid battery
regulations.
DO NOT dispose of with
regular refuse.
INSTRUCTIONS FOR:
RECHARGEABLE SPOTLIGHT
10,000,000 CANDLE POWER
MODEL No:
AK438.V2
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product
will, if used according to these instructions and properly maintained, give you years of
trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE
THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE
FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1.
SAFETY INSTRUCTIONS
1.1. GENERAL
Ensure the spotlight is correctly charged before initial use.
When fully charged and on full beam, the spotlight must not be used for
more than 15 minutes of continuous use. To do so may damage the
lamp.
WARNING! The lens becomes very hot during operation.
DO NOT cover or block the lens during use.
DO NOT turn the spotlight on when it is being re-charged.
DO NOT shine directly into your, other person’s or animal’s eyes.
DO NOT stand the spotlight near any surface or item that may be
adversely effected by the heat emitted from the lens.
DO NOT allow children to use the spotlight.
DO NOT handle or move the spotlight whilst it is being charged.
DO NOT use the spotlight if you suspect that the battery or the spotlight
casing is damaged.
DO NOT handle spotlight bulb with your fingers. Use a soft lint-free cloth.
Ensure that genuine and correctly rated battery and bulb are used for
replacements.
When not in use store the spotlight in a safe, dry, childproof location.
Sole UK Distributor, Sealey Group, Kempson
Way, Suffolk Business Park
, Bury St. Edmunds,
Suffolk, IP32 7AR
01284 757500
01284 703534
NOTE: It is our policy to continually improve products and as such we reserve the right to
alter data, specifications and component parts without prior notice.
IMPORTANT: No
liability is accepted for incorrect use of this equipment.
WARRANTY: Guarantee is 12
months from purchase date, proof of which will be required for any claim.
INFORMATION:
For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your
full name and address, including postcode.
1.2. BATTERY SAFETY
DANGER! - BE AWARE, LEAD-ACID BATTERIES MAY BE DANGEROUS
IF NOT HANDLED WITH CARE AND ACCORDING TO THESE
INSTRUCTIONS.
,
Before exposing the battery for replacement, remove personal metallic
items such as rings, bracelets, necklaces and watches. A lead-acid
battery can produce a short-circuit current high enough to weld a ring
to metal, which would cause severe burns.
DO NOT smoke or allow a spark or flame in the vicinity of the battery.
Ensure the charger is switched off and disconnected from the spotlight
before attempting to open the lamp unit.
If the battery wire terminals are corroded or dirty, clean them before
replacing battery.
DO NOT dis-assemble the battery for any reason.
WARNING! DO NOT allow metal tools to touch both battery terminals
simultaneously. Arcing or short circuit will result.
DO NOT allow battery wires to touch each other or to make contact
with any other metallic part.
DO NOT cross-connect wires to the battery as this will damage the unit.
Ensure positive (+) (RED) is to positive and negative (-) BLACK is to
negative.
DO NOT leave battery in a discharged state, recharge battery
immediately.
If the spotlight is not in use, recharge the battery every three months.
Dispose of the old battery in accordance with local authority acid battery
regulations.
DO NOT dispose of with regular refuse.
3. MAINTENANCE
www.sealey.co.uk
W e b
fig.8
fig.7
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycle centre and
disposed of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in
an environmentally protective way.
fig.6
Original Language Version
AK438.V2 Issue: 4(I) - 13/12/13
Original Language Version
AK438.V2 Issue: 4(I) - 13/12/13
© Jack Sealey Limited
© Jack Sealey Limited