Sealey PS983 - Manual

p WARNING! Ensure all Health and Safety, local authority, and general workshop practice regulations are strictly adhered to when using tools.
7 DO NOT use tools if damaged or worn.
3 Maintain the tools in good and clean condition for best and safest performance.
3 Ensure all threads are clean and well lubricated.
3 Always check that puller is correctly assembled and is square with the workpiece.
3 Ensure the nuts and bolts are tight on the jaw heads.
3 If vehicle is raised, ensure it is adequately supported with axle stands, ramps, etc. as appropriate.
3 Wear suitable clothing to avoid snagging. Do not wear jewellery. Tie back long hair.
3 Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.
3 Where possible shield workpiece with canvas or similar to provide protection against failed parts.
7 DO NOT heat puller jaws when heating a gear or bearing as this will affect the temper and, therefore, the strength of the material.
7 DO NOT hit workpiece with a hammer if workpiece has not moved with maximum puller force applied. Use a larger capacity puller.
3 Account for all tools and parts being used and do not leave them in or on the vehicle.
IMPORTANT: Always refer to the vehicle manufacturer’s service instructions, or proprietary manual, to establish the correct procedure and data.
INSTRUCTIONS FOR:
SLIDE HAMMER PULLER SET
MODEL NO:
PS983
2. INTRODUCTION AND SPECIFICATION
Item Part No. Description
1 PS983/601 T Bar
2 PS983/602 Hammer
3 PS983/603 Axle puller
4 PS983/604 Grip wrench adaptor
5 PS983/605 Nut
6 PS983/606 2 Jaw Head
7 PS983/607 3 Jaw head
8 PS983/608 Nut and Bolt (x3)
9 PS983/610 Attachment
10 PS983/611 Leg (x3)
11 PS983/612 Screw
12 PS983/613 Hook
13 PS983/614 Centre screw
15 PS983/B2 Deep Axle puller
1. SAFETY INSTRUCTIONS
3. CONTENTS & PARTS
The PS983 Slide hammer puller set with 570mm shaft consists of 18 pieces for use in 8 modes; External 3 jaw puller, internal 3 jaw puller,
external 2 jaw puller, internal 2 jaw puller, grip wrench adaptor, lip puller, hub puller and dent puller. Supplied in a carrying case.
PULLER TYPE: 2 LEGGED 3 LEGGED
Internal Capacity: 35-110mm Reach: 82mm 50-135mm Reach: 82mm
External Capacity: 50-140mm Reach: 75mm 20-135mm Reach: 75mm
PARTS LIST
Issue Date:- 041105
Issue No.:- 4
01284 757500
01284 703534 [email protected]
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
www.sealey.co.uk
Web
email
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our catalogue and latest promotions call us on 01284 757525 and leave your full name, address and postcode.
PS983 - 1 - 041105