Home maintenance guide – Eureka Vacuum System Cleaner User Manual

Page 6

Advertising
background image

Cloth Filter

If the disposable paper bag is full or a filter is clogged, no air can pass through the unit and no cleaning will take place.
Remove and dispose of the paper bags.

NOTE: Disconnect power cord from electrical outlet before cleaning the filter.

NOTE: The cloth filter must remain in place even if the paper filter is used.

The elbow with the paper bag adapter must be installed, locked in its L slots, in the body facing downward as shown for the
paper bag.

1.

Remove the lower dirt recptacle.

2.

Wrap a large garbage bag around the lower portion of the power unit and hold firmly in position.

3.

Grasp the cloth filtr through the plastic bag and shake. Dirt will drop into bag.

4.

Carefully remove the plastic bag from the unit and discard.

5.

Replace the dirt receptacle on unit.

Replacement of the Cloth Filter Bag

NOTE: Removal of cloth filter is not advised and is not normally necessary.

The band in the rim of cloth filter must be secured into corresponding groove in Intermediate Body to
ensure an airtight seal.

If for any reason, the cloth filter has been dislodged during shipment it must be reinstalled prior to use.

Fold back filter band, align it with groove in body and uncoil. Final portion of band should require a slight
push to POP it into place. If not, remove and repeat installation procedure.

HOME MAINTENANCE GUIDE

If you experience trouble with your built-in vacuum system, follow the suggestions below before calling for service.

LOSS OF SUCTION POWER:

Be sure lid is on properly.

Empty dirt receptacle.

Clean filter.

Be sure each inlet valve is properly closed.

Check for hose obstruction.
Plug hose coupling into any inlet valve. Then, as you check each of the other inlet valves, raise the inlet cover and hold
your hand over the opening to check for suction. If there is normal suction at each inlet, then insert the hose into one
of the other inlets. If there is no suction through the hose at the second inlet, the blockage is in the hose. To clear the
hose obstruction, insert a blunt instrument into the hose (garden hose, wood dowel). If there is one inlet valve without
normal suction and you have checked for hose blockage, then the blockage is in the pipe system between the blocked
inlet valve and the power unit (see instructions below).

Clear blockage in pipes
Insert the hose into the inlet valve where there is no suction; hold your hand over the hose end. Release hand quickly.
Repeat several times. If blockage does not clear, contact your nearest service station/dealer.

POWER UNIT WILL NOT START:

• Reset the overload protection device by following the directions on the Overload Protection Reset section of the manual.

NOTE: The safety device breaks the circuit of the motor is overloaded.

• Check for blown fuse in main house supply box.
• Unplug the power unit from the electrical outlet and check all wall inlet and motor wiring connections for loose wires.

POWER UNIT WILL NOT STOP RUNNING:

• Check inside each inlet valve for obstruction of low voltage contacts. If no visual obstruction can be detected, discon-

nect the vacuum from the electrical outlet and contact your nearest service station/dealer.

6

Advertising