Handrail set lhe 150 a1 intended use, Technical data, Items supplied – Livarno LHE 150 A1 User Manual

Page 9: Assembly material required, Assembly, Attention

Advertising
background image

- 8 -

HANDRAIL SET LHE 150 A1

Intended use

This handrail serves as a holding and guiding
opportunity when climbing stairs.
Assembly in commercially or publicly used buildings
is considered to be improper use.

Technical Data

Length:

approx. 155 cm

(with fi tted end caps)

Diameter:

approx. 4.2 cm

Weight :

approx. 2 kg

Items supplied

1 x Handrail
2 x End caps (pre-assembled)
2 x Ball ring holders
2 x S12 Wall plugs
2 x Hanger bolts M8 x 70
4 x Sunken-head screws M5 x 8

Assembly material required

Drill

Drill bit 12 mm

Crosshead screwdriver

Allen key SW4

Assembly

Unpack the individual items, check that all items as
listed are available and they are undamaged.

Note:

As per DIN 18065, a handrail must be

at least 90 cm high.
The measurement is taken at the step front edge.

1. Measure the minimum height for the handrail

from the step front edge and mark the two
boreholes.

ca. 125 cm

Fig. Handrail minimum height

Attention:

The supplied wallplugs are suitable

only for an attachment being made to a concrete or
brick wall. Please be sure to check your masonry for
its suitability for the wallplugs before carrying out the
attachment. If in doubt, consult a specialist.

2. Drill the holes with a 12 mm drill and insert the

plugs into them.

3. Screw the ball ring holders to the wall.

Fig. Assembly of the ball ring holders

Advertising