Livarno Z31336 - Manual (Page 8)

8 GB
Select the desired mode using the buttons
5 – 10 (see Fig. A):
– Set the brightness by using one of the five
different brightness buttons 5 .
Note: The brightness buttons cannot be
used in the automatic colour change mode
(button A
8 ).
– Press the M button 6 to change the colour
of the light manually. With each new press
of the M button, the colour changes into
different colours.
– If you store a desired colour during the
automatic colour changing sequence or
M mode by pressing the S button
7 . The
stored colour will be displayed when the
device is switched on again.
– Press the A button to switch on the
automatic colour-changing function.
– Press the button 9 to change to white
light.
– Press one of the colour buttons 10 to change
into the desired colour directly.
Note: The remote control handset has a
range of 4 metres. Hold the remote control
handset with the IR diode
14 above and
pointing directly at the lamp.
Replacing a bulb
Press the 0 button 3 to switch off the
colour-changing lamp.
Allow the lamp 1 to cool for at least
10 minutes.
Screw the old lamp out of the fitting
(see “Use”).
Screw a bulb of the same type into the fitting.
When doing this, ensure that the lamp is se-
curely seated.
Maintenance and cleaning
CAUTION! RISK OF ELECTRIC SHOCK!
For electrical safety reasons, never clean the
lamp
1 with water or other fluids nor im-
merse it in water.
Do not use solvents such as petrol and the
like as they could damage the lamp.
Allow the lamp to cool for at least 10 minutes.
Use a dry, fluff-free cloth for cleaning.