Marshall Electronics CV350-5XB - Manual

1080 HD-SDI 5X Autofocus Lens Day/Night Camera
Design and specifications are subject to change without notice.
Panasonic 2.3 Megapixel CMOS
5x Optical Zoom, F=4mm ~ 20mm, F2.8 ~ F3.9
HD-SDI(BNC), HDMI, and Analog CVBS (BNC)
0.2Lux (Color), 0.1Lux (B/W), 0.005Lux (DSS On)
Optical Multi Coated ICR Filter
3D-DNR, Privacy masking
Defog, HLC, WDR
Full OSD control
12VDC
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
PRECAUTIONS
REGULATORY NOTICE
FEATURES
HARDWARE OVERVIEW: Front SPECIFICATIONS
DIMENSIONS
WARNING
!
Do not use the camera if fumes, smoke or a strange odor is emitted
from the unit, or if it seems to not function correctly. Disconnect the
power source immediately and consult your supplier.
CAUTION

Always follow the instructions in the installation guide when
applying power. Fire and equipment damage can occur if power
is applied incorrectly. For the correct power supply, refer to the
CAUTION
 Do not install or operate in small, unventilated areas. Heat build up
CAUTION
 To prevent damage, do not drop the camera or subject it to strong
CAUTION
 If installed close to a TV, radio transmitter, magnet, electric motor
interfere with or distort the image.
CAUTION

Whether or not the camera is used outdoors, never point it toward
the sun. Use caution when operating the camera in the vicinity of spot
CAUTION

Do not use the camera in extreme environments where high
temperatures or high humidity exists. Use the camera under
conditions where temperatures are between 14°F ~ 122°F (-10°C ~
50°C), and humidity is below 90%.
shock or vibration.
HARDWARE OVERVIEW: Rear
CV350-5X (Signal type: 1080P25/30, 1080i50/60, 720P50/60, 1080P50/60)
CV350-5XB (Signal type: 1080P29.97, 1080i59.94, 1080P59.94, 720P59.94)
5x Auto Focus Lens
Remote Control IR Receiver
Hole for wall or
ceiling mount
Z/F & Menu
Controls Key
Analog Video Output
HD-SDI Video Output
1. Alarm output for Motion detection
2. External Day/Night input
3. GND
4. RS-485 Remote control: -
5. RS-485 Remote control: +
HDMI Video Output
Power LED Indicator
Power Input
12VDC
Remote Control
IR Receiver
Z/F & Menu Controls Key
MENU On, One Push AF Key
Menu On: Press and hold menu key for 2seconds to display menu.
Menu Mode: To select data or exit from menu, press menu key.
One Push AF: To adjust focus position, press and release menu key when One Push AF mode is enabled.
Focus NEAR: Press and hold right key for continuous optical focus near.
MENU: To change menu parameter, press right key while menu is displayed.
Focus Far: Press and hold left key for continuous optical focus far.
MENU: To change menu parameter, press left key while menu is displayed.
Zoom TELE: Press and hold up key for continuous optical zoom in(Tele).
MENU: To move up menu item, press up key while menu is displayed.
Zoom WIDE: Press and hold down key for continuous optical zoom out(Wide).
MENU: To move down menu item, press down key while menu is displayed.
Image Sensor 1/2.86” Progressive CMOS (Approx. 2.3 mega)
Scanning System 16:9 Progressive
Sync. System Internal
Effective Pixel 1920(H) x 1080(V)
Min. Illumination 0.2Lux (Day), 0.1Lux (Night), 0.005Lux(DSS on)
Horizontal Resolution 1000TVL
Lens 5x Optical Zoom, F=4.0~20mm, F2.8 ~ F3.9
Zoom 5x optical zoom + 12x digital zoom = 60x
Focus Near/Far, Auto/Manual/One Push
Angle of View(H) 64.2 degrees(WIDE), 13.8 degrees(TELE)
Back Light Compensation WDR/BLC, HLC(High Light compensation)
Exposure Auto / Manual
White Balance Auto(3,000°K~8,000°K) / ATW(1,900°K~11,000°K) / Manual
Day & Night System AGC / TDN(ICR)
Electronic Shutter NTSC: 1/30~1/30000, PAL: 1/25~1/30000, DSS( ~ 1/1sec)
Functions Privacy Mask, Image Mirror, 3DNR, Flicker-less, Sharpness, Defog
800mVp-p, 75Ω, unbalanced generator(single-ended)
CVBS (NTSC/ PAL) Analog Composite(1V ± 0.2 Vp-p) NTSC/PAL
HD Output
HDMI [email protected], [email protected],
[email protected], [email protected]
PELCO-P/D, SONY-VISCA protocol
8bits data, 1 stop bit, no parity, 2400~115200bps
D/N input OPEN(floating): Day mode, CLOSE: Night mode
Motion Detection out
High level signal(5VDC) output.
MD output use transistor, connect lower than 100mA load.
Operation Temperature -10℃ ~ 50℃
Power Input 12VDC (7V to 15VDC)
Power consumption Max 6W (4.8W Lens inactive, 5.5W Lens active)
Weight 274g (0.6Lbs)
Dimensions (D x W x H) 53.7 x 36.3 x 34.8mm (2.11 x 1.42 x 1.37")
RS485
General
Video
Output
Control
Interface
SMPTE 292M(1.485Gbps): [email protected], [email protected]
SMPTE 424M (2.97Gbps): [email protected]
Sensor
Optics
Functions
SDI Output