RISCO Group Agility 2-Way Wireless Keypad - Manual

1
Agility 2-Way Wireless Keypad
INTRODUCTION
The 2-Way keypad is used to remotely program and operate the Agility security system. Being bi-directional the 2-Way keypad receives a reply status
indication from the panel for each command that it has sent to the panel. To use functions of the keypad you can use a code or a proximity tag.
MAIN FEATURES
 Bi-directional Wireless Communication
 Full wireless engineer programming
 Up to 3 Wireless keypads per system
 S.O.S / Two way communication emergency key
 Proximity tag operation
 Double tamper protection (Box & Wall)
 Battery economy mode
COMMUNICATION SETUP
The 2-Way keypad must identify itself to the system receiver. This can be done by using RF mode.
Setup using RF communication:
1. Set the receiver to Learn Mode by pressing the large button on the main unit for 10 seconds.
2. Send a Write message by pressing both keys simultaneously for at least 2 seconds. The keypad will sound a confirmation beep and the
system will sound an allocation message.
3. If required to change the keypad's default settings configure the keypad's parameters according to the system installation manual.
Note :
Adding the keypad to the system can be done remotely using the configuration software by entering the serial number of the keypad.
MOUNTING THE KEYPAD
Mount the keypad on the wall using the supplied mounting bracket.
Note :
Before mounting the keypad test the keypad communication with the system.
1. Release the Mounting bracket captive screw (1).
2. Slide up the Main Unit (3) to release it from the two mounting bracket's locking tabs (2).
3. Mount the bracket.
Figure 1 Figure 2
4. Release the battery cover screw (1) and place the supplied 3 batteries.