RISCO Group IR Beam 72 Outdoor Detector - Manual

‐1‐
IR Beam 72
(Beam 7225/Beam 7250/Beam 7275)
Installation Guide
1. Introduction
The IR Beam 72 outdoor detectors employ twin beams with advanced optics and four selectable channels, providing reliable detection.
2. Layout
Cover
Screw
Wire Entry
4 Channel Option Switch
Optical Axis Monitor Jack (Receiver)
Optical Axis Rotation
Reflector and Filter
Bracket and Base Attaching Holes
Optical Axis Windows
Optical Axis Screw
Response Speed VR (Receiver)
Terminal Block
13 LED
Sense LED
D‐belt for pole mounting
(purchased separately ‐ P/N: RBM72P00000A)
Bracket
3. Mounting Location 4. Installation Method
1. Mount the transmitter and receiver within maximum range.
2. In case the received signal is low, install within rotation angle range
of the reflector.
3. Avoid direct sunlight (facing
sunrise or sunset) or
headlamps.
4. Avoid obstacles (flowerpots,
laundry, pets) between receiver and
transmitter.
5. When installing several detectors or cross installation to avoid
collision install according to the following diagram:
6. Do not install on unstable
surfaces. 7. After mounting, adjust optical
axis and conduct a walk test.
1. To remove front cover,
unscrew front bottom screw.
3. Mount on desired wall or pole
and connect wires through wire
entry (see terminal block).
4. Connect the wire through the
upper terminal block. Replace
the bracket and fixing screw.
2. To separate bracket from
detector, unscrew bottom screw.
When mounting two
brackets on one pole, install a
pair of D‐belts at the upper and
lower parts and install another
D‐belt in the middle for equal
mounting height.
5. Adjust the optical axis and
conduct a walk test. Then,
replace front cover.