Nikon D7200 body - Manual (Page 172)

148
A
Lowering the Built-in Flash
To save power when the flash is not in use,
press it gently downward until the latch
clicks into place.
D
The Built-in Flash
Remove lens hoods to prevent shadows. The flash has a minimum
range of 0.6 m (2 ft) and can not be used in the macro range of zoom
lenses with a macro function. i-TTL flash control is available at ISO
sensitivities between 100 and 12800; at values over 12800, the desired
results may not be achieved at some ranges or aperture values.
If the flash fires in continuous release modes ( 0 66), only one picture
will be taken each time the shutter-release button is pressed.
The shutter release may be briefly disabled to protect the flash after it
has been used for several consecutive shots. The flash can be used
again after a short pause.
A Shutter Speeds Available with the Built-in Flash
The following shutter speeds are available with the built-in flash.
Mode Shutter speed
i, p, n, s, w, 0, g, P * , A * 1 /
250
– 1 /
60
s
k 1 /
250
– 1 /
30
s
o 1 /
250
–1 s
S * 1 /
250
–30 s
M * 1 /
250
–30 s, A, %
* Speeds as fast as 1 /
8000
s are available with optional flash units that support auto FP high-
speed sync when 1/320 s (Auto FP) or 1/250 s (Auto FP) is selected for Custom
Setting e1 ( Flash sync speed, 0 282). When 1/320 s (Auto FP) is selected,
shutter speeds as fast as 1 /
320
s are available with the built-in flash.