Canon EOS 1D X Mark II - Manual (Page 22)

22
This section describes the process following the connection
instructions. If an error is displayed, see “Troubleshooting Guide” in
Chapter 10 (p.117) and check the settings.
 Pressing the shutter button or other camera controls during
configuration using the connection instructions will close the
connection instructions. Do not press the shutter button or other
controls until configuration is finished.
 Under the [52] tab, set [Auto power off] to [Disable]. If auto power
off is activated, the connection instructions will be closed during the
configuration process.
1
Select [Communication settings].
 Under the [53] tab, select
[Communication settings], then
press <0>.
2
Select [Network settings].
 Set [Communication func] to
[Enable], then select [Network
settings].
3
Select [Connection settings].
Displaying the Connection Wizard