Panasonic Lumix GX8 - Manual (Page 381)

381
13. Others
• There may be defective pixels in the image sensor.
> Perform [Pixel Refresh] (P83) .
• Set the AF area to the distinctive color of the subject if there is a part that is different from the
surrounding color.
(P147)
• Is your finger covering up the speaker? (P17)
• If the camera is moved too slowly, the camera has assumed that camera motion was stopped
and will end the still picture recording.
• If there is a great deal of shaking towards the recording direction while moving the camera,
recording will end.
• When the ambient temperature is high or recording with [ ] ([4K Burst]) or [ ]
([4K Burst(S/S)]) of the 4K Photo function is performed continuously, the camera may display
[
] and stop the recording to protect itself. Wait until the camera cools down.
• You may not be able to record for a short while after turning this unit on when using a large
capacity card.
• When the ambient temperature is high or motion picture is recorded continuously, the camera
may display [
] and stop the recording to protect itself. Wait until the camera cools down.
• Depending on the [Rec Format] and [Rec Quality] of a motion picture, the speed class rating
required for the card differs. Use a card that meets the rating. For details, refer to
“ About motion
picture/4K photo recording and speed class ratings ” on P22 .
• When a card with a slow data writing speed is used, motion picture recording may stop midway.
> If a card on which recording and deleting have been repeated many times or a card that
has been formatted on a PC or other equipment is being used, we recommend that you
make a backup of the data and format
(P33) the card on the unit.
Bright spot not in subject is recorded.
Subject cannot be locked.
(AF tracking not possible)
Operation sound is small.
Recording by Panorama Shot Mode is ended before finishing.
4K photo recording stops before finishing.
Motion pictures
Recording motion pictures is not possible.
Motion picture recording stops in the middle.