Sony Cyber-shot DSC-RX100 IV - Manual (Page 177)

Sets the display for the counter, time code, and user bit.
TC Preset:
Sets the time code.
UB Preset:
Sets the user bit.
TC Format:
Sets the recording method for the time code.
TC Run:
Sets the count up format for the time code.
TC Make:
Sets the recording format for the time code on the recording medium.
UB Time Rec:
Sets whether or not to record the time as a user bit.
How to set the time code (TC Preset)
1.
MENU →
(Setup
) → [TC/UB Settings] → [TC Preset], then press
in the center
of the control wheel.
2. Turn the control wheel and select the first two digits.
The time code can be set between the following range.
When [60i] is selected: 00:00:00:00 to 23:59:59:29
*
When [24p] is selected, you can select the last two digits of the time code in
multiples of four from 0 to 23 frames.
When [50i] is selected: 00:00:00:00 to 23:59:59:24
3. Set the other digits following the same procedure as in step 2, then press in the
center of the control wheel.
Note
When you tilt the monitor to shoot a self-portrait, the time code and user bit will not be
displayed.
How to reset the time code
1.
MENU →
(Setup
) → [TC/UB Settings] →[TC Preset], then press
in the center
of the control wheel.
2. Press the (Delete) button to reset the time code (00:00:00:00).
You can also reset the time code (00:00:00:00) using the RMT-VP1K remote commander
(sold separately).
How to set the user bit (UB Preset)