Sony Cyber-shot RX10 III - Manual (Page 261)

Make sure that [SteadyShot] is set to [On].
The picture was taken in a dark location without the flash, resulting in camera-shake. The
use of a tripod or the flash is recommended. [Hand-held Twilight] and [Anti Motion Blur] in
[Scene Selection] are also effective in reducing blur.
[321] Troubleshooting Troubleshooting Shooting still images/movies
The monitor darkens after a short period of time passed.
If you do not operate the product for a certain period of time, the product switches to the
power-save mode. The product exits power-save mode when you perform operations
such as pressing the shutter button halfway.
[322] Troubleshooting Troubleshooting Shooting still images/movies
The flash takes too long to recharge.
The flash has been fired in succession in a short period. When the flash has been fired in
succession, the recharging process may take longer than usual to avoid overheating of
the camera.
[323] Troubleshooting Troubleshooting Shooting still images/movies
The control dial or control wheel does not work.
[Dial / Wheel Lock] is on. Hold down the Fn button until the lock is released, or set the
[Dial / Wheel Lock] to [Unlock].
[324] Troubleshooting Troubleshooting Shooting still images/movies
Sound is not recorded properly.