Sharp MX-6070N - Manual (Page 124)

1-121
BEFORE USING THE MACHINE►PERIPHERAL DEVICES
SADDLE STITCH FINISHER
This includes the offset function that outputs sorted paper while staggering each set of paper, the staple sort function
that staples each set of prints, the saddle stitch function that automatically staples the centre of the sheets and folds the
sheets in half, and the paper folding function that folds paper in half.
To punch holes in printed paper, install an optional hole punch module.
PART NAMES
(1) Output tray (upper tray)
The tray is slidable. To print on large paper such as A3
paper, extend the tray.
(2) Output tray (lower tray)
Stapled and offset output is delivered to this tray.
The tray is slidable. To print on large paper such as A3
paper, extend the tray.
(3) Top cover
Open this cover to remove a paper misfeed.
(4) Saddle stitch tray
Saddle-stitched output is delivered to this tray.
(5) Front cover
Open this cover to replace the staple cartridge, remove a
staple jam, or remove a paper misfeed.
(3) (1) (2)
(5) (4)
• To install a saddle stitch finisher, a paper pass unit and stand/550/2x550/3x550/550&2100 sheet paper drawer are
required.
• Do not place heavy objects on the saddle finisher or press down on the saddle stitch finisher.
• Exercise caution when you turn on the power and when printing take place, as the tray may move up and down.
• A saddle stitch finisher cannot be installed simultaneously with an inner finisher, finisher, finisher (large stacker) or saddle
stitch finisher (large stacker).