Multiple monitor connection, Connecting peripheral equipment, Connection with video cable – Sharp PN-V602 User Manual

Page 13

Advertising
background image

13

E

Connecting Peripheral Equipment

TIPS

• The length of the signal cables or surrounding environment

may affect the image quality.

• The screen may not display properly when using terminals

other than PC DVI-D/AV DVI-D for the input mode. In this

case, turn off the power to all the monitors connected in a

daisy chain and then turn the power on again.

• When connecting monitors in a daisy chain set AUTO

INPUT CHANGE to OFF.

• Video output is disabled in the following cases:

When the power is turned off

When the monitor is in input signal waiting mode

10. LAN terminal

• You can control the monitor from a PC on a network by

connecting a commercially available LAN cable between

this terminal and a network.

11. External speaker terminals

• Be sure to use external speakers with an impedance of 6 Ω

or greater and a rated input of at least 10 W.

3

2

1

Approx.

3-15/16 inch

(10 cm)

1. Attach a speaker cable core (included with the PN-ZB02) to

the end of the speaker cable connected to the monitor.

2. While pushing the tab, insert the tip of the cable.

3. Release the tab.

TIPS

• Be sure to connect the + and - terminals and the left and

right speakers properly.

• Avoid short circuiting the + and - terminals.

12. Audio1 input terminals

13. Audio2 input terminals

• Set the audio input terminal to be used in each input

mode in AUDIO SELECT on the OPTION menu.

14. PC RGB input terminals

• Set BNC of INPUT SELECT on the OPTION menu to PC

RGB when using the PC RGB input terminals.

• Select the audio input terminal to be used in PC RGB of

AUDIO SELECT on the OPTION menu.

15. AV component input terminals

• Set BNC of INPUT SELECT on the OPTION menu to AV

COMPONENT when using the AV component input terminals.

• Select the audio input terminal to be used in AV

COMPONENT of AUDIO SELECT on the OPTION menu.

• Cannot be used when D-SUB in INPUT SELECT on the

OPTION menu is set to AV COMPONENT.

16. AV video input terminal

• Select the audio input terminal to be used in AV VIDEO of

AUDIO SELECT on the OPTION menu.

• Cannot be used when D-SUB in INPUT SELECT on the

OPTION menu is set to AV VIDEO.

17. AV S-video input terminal

• Select the audio input terminal to be used in AV S-VIDEO

of AUDIO SELECT on the OPTION menu.

Multiple monitor connection

The monitors can be aligned and used as a large screen.
[Example]

Second monitor

Secondary

(Expansion unit)

ID No.: 2

Third monitor

Secondary

(Expansion unit)

ID No.: 3

First monitor

Primary

(Main unit)

ID No.: 1

Fourth monitor

Secondary

(Expansion unit)

ID No.: 4

Remote control sensor box

(Supplied with the PN-ZR01 (optional))

TIPS

• Connect the RS-232C cables in order, starting with the first

monitor (primary monitor). If monitors are connected in a

different order they may not be operable.

• Always install the remote control sensor box on the primary

monitor.

■ Connection with video cable

May vary depending on the system being used.

If using the PC/AV DVI-D terminal, up to 5 monitors can be

connected in a daisy chain. (When the PN-ZB02 is attached)

shows the

signal flow

PC/AV DVI-D

input terminal

First monitor

Second monitor

PC/AV DVI-D

output terminal

PC/AV DVI-D

input terminal

Digital signal (DVI) cables

(commercially available)

To PC digital RGB output terminal

Advertising
This manual is related to the following products: