Controlling with a pc, Basic operation, Controlling the monitor with a pc (lan) – Sharp PN-V602 User Manual

Page 47

Advertising
background image

47

E

47

7. Specify the “DHCP CLIENT”, “IP ADDRESS”,etc.

DHCP CLIENT
If your LAN has a DHCP server and you wish to obtain an

address automatically, change this setting to “ON”.

To set the address manually, set this to “OFF”.
IP ADDRESS
If the DHCP CLIENT is set to “OFF”, specify an IP

address.
SUBNET MASK
If the DHCP CLIENT is set to “OFF”, specify the subnet

mask.
DEFAULT GATEWAY
If the DHCP CLIENT is set to “OFF”, specify the default

gateway.

If you are not using a default gateway, specify “0.0.0.0”.

8. When the setting is changed, click [Apply].

9. Check the message and click [OK].

10. Exit Internet Explorer.

11. Restore the PC’s IP address jotted in Step 6, “(2)

Specifying the PC’s IP address”.

12. Connect the monitor and the PC to the LAN.

Caution

• Wait 10 seconds after clicking [OK] before proceeding.

• When operating using the remote control unit or similar,

click [Refresh].

TIPS

• When manually setting the IP address, the IP address

for secondary monitors connected by RS-232C can be

automatically allocated. (See page 25.)

Controlling with a PC

■ Basic operation

You use Internet Explorer on a PC on the LAN to control the

monitor.

1. Launch Internet Explorer on the PC.

2. In the “Address” box, type “http://” followed by your monitor’s

IP address followed by “/”, then press the Enter key.

You can confirm the IP address with the DISPLAY function.

When prompted to enter a user name and password, type

the user name and password that you specified in the

security settings (see page 49), and click [OK].

If you did not make any security settings, leave the spaces

blank and click on [OK].

3. You can check, control, and change the monitor’s status

and settings by clicking the menu items on the left side of

the screen.

• If you see an [Apply] button next to a setting, click it after

you change that setting.

TIPS

• See pages 48 to 52 for details on each setting.

• If you click [Refresh] before the screen finishes updating

the current display, the “Server Busy Error” will appear.

Wait for a moment before operating your monitor again.

• You cannot operate the monitor while it is warming up.
• If “DHCP CLIENT” is set to “ON”, press

DISPLAY

on the

remote control unit two times and then check the monitor’s

IP address.

Controlling the Monitor with a PC (LAN)

Advertising
This manual is related to the following products: