Lan setup / security / general, Controlling the monitor with a pc (lan) ■ snmp – Sharp PN-U423 User Manual

Page 43

Advertising
background image

43

E

■ LAN SETUP / SECURITY / GENERAL

This screen allows you to set the settings necessary when the

monitor is connected to a LAN.

DHCP CLIENT
If your LAN has a DHCP server and you wish to obtain an

address automatically, change this setting to ON.

To set the address manually, set this to OFF.
IP ADDRESS
If the DHCP CLIENT is set to OFF, specify an IP address.
SUBNET MASK
If the DHCP CLIENT is set to OFF, specify the subnet mask.
DEFAULT GATEWAY
If the DHCP CLIENT is set to OFF, specify the default

gateway.

If you are not using a default gateway, specify “0.0.0.0”.
USER NAME / PASSWORD / Confirm PASSWORD
Sets up a user name and password to restrict access to this

monitor.

For confirmation, reenter the password you entered in

PASSWORD in Confirm PASSWORD.
AUTO LOGOUT TIME
Specify the time (in minutes) to elapse before automatically

disconnecting this monitor from the network.

Specify in minutes from 1 to 65535. A value of ‘0’ will disable

this function.
DATA PORT
Specify the TCP port number to use for exchanging data with

the monitor.

Specify a value from 1025 to 65535.
SEARCH PORT
Specify the port number to use when searching for this

monitor.

Specify a value from 1025 to 65535.

TIPS

• After you have changed the settings, click [Apply].

• After you have changed the settings in DATA PORT and

SEARCH PORT, click [Reboot].

Controlling the Monitor with a PC (LAN)

■ SNMP

You can configure settings related to SNMP.

SNMP SETTING
Set whether to enable or disable SNMP.
COMMUNITY NAME 1 to 3
Set the name of the community required for the access.
TRAP SETTING
Set whether to enable or disable the trap function.

When this function is enabled, a trap will be sent when the

monitor is turned on.
TRAP SETTING OF AUTHENTICATION ERROR
Set whether the trap function sends a notification when

authentication fails.
TRAP ADDRESS & PORT
Set the destination address and port number of the

notification sent by the trap function.

TIPS

• After you have changed the settings, click [Apply].

Advertising
This manual is related to the following products: