Mounting precautions – Sharp PN-U423 User Manual

Page 6

Advertising
background image

4

E

MOUNTING PRECAUTIONS

• This product is for use indoors.
• A mounting bracket compliant with VESA specifications is

required.

• Since the monitor is heavy, consult your dealer before

installing, removing or moving the monitor.

• Do not hold the monitor by the speakers.
• Mounting the monitor on the wall requires special expertise

and the work must be performed by an authorized SHARP
dealer. You should never attempt to perform any of this
work yourself. Our company will bear no responsibility
for accidents or injuries caused by improper mounting or
mishandling.

• Use the monitor with the surface perpendicular to a level

surface. If necessary, the monitor may be tilted up to 20
degrees upward or downward.

• This monitor should be used at an ambient temperature

between 41°F (5°C) and 104°F (40°C).
(32°F (0°C) and 104°F (40°C) for the PN-U473/PN-U423)
Provide enough space around the monitor to prevent heat
from accumulating inside.

Unit: inch [mm]

For the monitor in portrait orientation

7-7/8 [200]

2

[50]

2

[50]

2 [50]

2

[50]

2 [50]

Power LED

For the monitor in landscape orientation

Unit: inch [mm]

5/16 [7]

5/16 [7]

7-7/8 [200]

2

[50]

• If it is difficult to provide sufficient space for any reason

such as the installation of the monitor inside a housing, or
if the ambient temperature may be outside of the range
of 41°F (5°C) to 104°F (40°C), install a fan or take other
measures to keep the ambient temperature within the
required range.
(32°F (0°C) and 104°F (40°C) for the PN-U473/PN-U423)

• Temperature condition may change when using the monitor

together with the optional equipments recommended by
SHARP. In such cases, please check the temperature
condition specified by the optional equipments.

• Do not block any ventilation openings. If the temperature

inside the monitor rises, this could lead to a malfunction.

• Do not place the monitor on a device which generates heat.

• Adhere to the following when installing the monitor in its

portrait orientation. Failing to adhere to the following may
cause malfunctions.
- Install the monitor such that the power LED is located on

the bottom side.

- Set the MONITOR on the MONITOR menu to PORTRAIT.

(See OPERATION MANUAL.)

- Be sure to clamp the power cord (supplied) onto the cable

clamp attachment using the supplied cable clamp.
When clamping the power cord, take care not to stress
the terminal of the power cord. Do not bend the power
cord excessively.

Cable clamp

Power cord (Supplied)

Cable clamp

attachment

• Use the supplied vertical sticker when you install the

monitor in portrait orientation.

Vertical sticker

(Operation panel)

Vertical sticker

(Logo)

Do not remove the factory-affixed sticker but affix the
sticker over it. Be careful not to cover the remote control
sensor or buttons.

Advertising
This manual is related to the following products: