Turning power on/off, English, Turning on the main power – Sharp PN-R603 User Manual

Page 9: Noperation mode, Ndate/time setting

Advertising
background image

ENGLISH

7

E

Turning Power On/Off

Caution

• Turn on the monitor first before turning on the PC or

playback device.

Turning on the main power

Main power switch

Caution

• The main power must be turned on/off with the main power

switch. Do not connect/disconnect the power cord or turn

the breaker on/off while the main power switch is on.

• When switching the main power switch or the POWER

button off and back on, always wait for at least 5 seconds.

• For a complete electrical disconnection, pull out the main

plug.

Turning power on/off

Press the POWER button or POWER switch to turn the power

ON/OFF.

Power switch Power LED

Status

Status of the monitor

Green lit

Power on

Orange lit

Power off (Standby mode)

Green flashing

Input signal waiting mode

Accessing the operation panel

n

Operation mode

When the monitor is turned on for the first time after being

shipped from the factory, the operation mode setting screen

will be displayed. Set it to MODE1 or MODE2.

MODE1 ... OFF IF NO OPERATION is set to ON, and

STANDBY MODE is set to LOW POWER. (These

settings can not be changed.)

If there is no operation for 4 hours or more, the

monitor automatically enters standby mode. Power

consumption in standby mode is also minimized.

MODE2 ... Will perform standard operation.

OFF IF NO OPERATION is set to OFF, and

STANDBY MODE is set to STANDARD. These

settings can be changed.

Even after being set, changes can be made using

OPERATION MODE, located in the menu of the monitor. (See
OPERATION MANUAL.)

n

Date/time setting

• If the time has yet to be set when the monitor is first turned

on, the date/time setting screen appears. Set the date and

time.

DATE/TIME SETTING

/

/

OK···[ENTER] CANCEL···[RETURN]

:

:

01

01

13

/

00

00

:

/ 20

1. Press

or

to select the date and time, and

press

or

to change the numerical values.

2. Press

ENTER

.

• Be sure to set the date and time.

• The date/time setting screen will close automatically if

no operation is performed for about 15 seconds. The

date and time can be set using DATE/TIME SETTING

from the SETUP menu when the date/time setting screen

disappears.

TIPS

Set the date in “Day/Month/Year” order.

Set the time on a 24-hour basis.

The clock is maintained by the internal battery.

If you already set the time but the date/time setting

screen appears when the power is turned on, the

internal battery may be exhausted. Please contact an

authorized SHARP servicing dealer or service center for

assistance with battery replacement.

Estimated service life of the internal battery: About 5

years (depending on monitor operation)

The initial battery was inserted at the factory when the

monitor was shipped, so it may run out of power before

its expected operation life.

Advertising
This manual is related to the following products: