Echo CS-330T - Manual (Page 11)

11
CHAIN LUBRICANT
Proper lubrication of the chain while in operation reduces friction
between the chain and the guide bar to a minimum and assures
a longer service life.
• use bar and chain oil of high quality for this purpose.
• Do not use used or reclaimed oil to avoid various oiler
problems.
• Use ECHO bar and chain oil.
• When ECHO bar and chain oil is not available:
Use motor oil, etc.
• Use bar and chain oil of the following grades:
SAE NO. 30 ..... in summer
SAE NO. 10 ..... in winter or when cutting resinous trees.
• When refueling, also refill chain oil.
STARTING COLD ENGINE
WARNING DANGER
Make sure bar and chain are not touching anything when starting
the saw.
1. Move chain brake lever (E) fully forward to lock chain brake
before starting.
2. Fill the fuel tank with fuel. Do not over fill.
3. Fill the chain oil tank with lubricant. Do not over fill.
4. Move ignition/choke lever (A) forward to “close choke” ( )
position.
5. Lay unit on a flat, clear area and keep bar and chain clear of
all obstacles. Hold top handle with one hand, and depress
throttle trigger lockout (C), but do not depress throttle trigger
(D).
6. Pull starter handle (F) several times until engine starts, or first
starting sound is heard. (7 pulls maximum)
7. Move ignition/choke lever back to “run” ( I ) position (B). (Do
not move to “Stop” position.) If necessary, start the engine.
NOTE
If engine does not start after 3 pulls with choke in “run” ( I )
position, repeat cold start instructions 4-6.
8. After engine starts, wait 5 seconds then depress and release
throttle trigger (D). Allow unit to warm up at idle for several
minutes.
O
PERATION
A
B
FUEL TANK OIL TANK
TANK INDICATION
C
D
E
C
F
IMPORTANT
This saw features a combination ignition/choke switch that
automatically sets the throttle speed to fast idle for quick
starting. Do not squeeze trigger during cold starts until
after unit has started, or fast idle and choke settings will
be released, and engine may not start.
NOTE
Do not pull starter rope out to the maximum
possible position.
Do not allow recoil handle to snap back
against the casing.