Ericsson Distribution Receivers RX8315 - Manual (Page 12)

Quick Start Guide: Connect-Power-Configure
3 Quick Start Guide: Connect-Power-Configure
3.1 Connecting the Receiver
The following points should be noted when making signal connections to the
receiver:
• If you have an incoming satellite RF feed, this should be connected to the rear
panel connector marked RF IN 1 - 4.
• If you have an incoming ASI feed, this should be connected to the ASI Input.
• Decoded PAL or NTSC video is output on connectors CVBS 1 and CVBS 2.
These outputs are identical in operation.
• Decoded analogue or digital audio is output on connectors AUDIO OUT 1 and
AUDIO OUT 2. Adaptor cables are used to provide the connector type required
for the installation.
• The incoming feed is routed through the unit and output on connectors
ASI OUT 1 and ASI OUT 2. This output can be service filtered with licenses
available for single (RX8XXX/SWO/SING/SERVFILT) and multiple
(RX8XXX/SWO/MULT/SERVFILT) service filtering software options.
• For models with option RX83XX/HWO/IP/OUT fitted, the incoming feed is also
routed through the unit and output on connectors IP OUT 1 and
IP OUT 2.
• If the unit is to be controlled by Web browser or SNMP based control system
then the control PC should be connected to connector CONTROL 1 or
CONTROL 2 (ETHERNET 1 or Ethernet 2).
• If the unit is to be used to decrypt (non-Director) encrypted feeds then a
PCMCIA Conditional Access Module and card should be inserted in the slot
labeled Conditional Access Interface in the rear panel of the unit.
3.2 Powering the Receiver
3.2.1 Switching On
Caution!
This equipment should not be operated unless the cooling fans are working and
there is free-air flow around the unit.
1. Connect all signal and power cables to the rear panel of the unit.
EN/LZT 790 0008/1 R1A 2011-03-30 12 (40)