Ericsson Distribution Receivers RX8315 - Manual (Page 13)

Quick Start Guide: Connect-Power-Configure
2. Switch on the AC power supply to the unit at the wall or rack outlet.
Note: The RX8310/15/30 Receivers do NOT contain a power on/off switch.
3. After a short period of initialization the following screen is displayed on the Front
Panel:
INITIALIZING
4.3.2 (Bank 0)
4. During initialization, confirm that the Status LED is on and all Up, Down, Left,
Right, Edit and Save pushbuttons are lit.
3.2.2 Power Up Operating Modes
When the equipment is switched on it will assume the control mode that was set
when the power was turned off. This could be either:
• Local Front Panel/Web Browser control.
• Director NCP control.
3.3 Configuring the Inputs
3.3.1 Transport Stream (ASI) Input
To configure the unit for ASI input:
1. Select ASI input from sub-menu Select Input.
3.3.2 Satellite (DVB-S or DVB-S2) Input (if fitted)
Ensure that the incoming feed is connected to connector RF IN 1.
To configure the unit for Satellite input, navigate to the front panel Input menu and
carry out the following steps:
1. Select SAT input.
2. Set the LNB frequency.
3. Set the Satellite frequency.
4. Set the Symbol Rate.
5. Set the Modulation scheme and FEC.
6. Set the Roll-Off.
7. Set the set the LNB power output.
EN/LZT 790 0008/1 R1A 2011-03-30 13 (40)