Extron Electronics DA 6V EQ - Manual (Page 4)

DA AV EQ Series • Quick Start Guide
Quick Start Guide — DA AV EQ Series
QS-1
To install and set up a DA AV EQ Series distribution amplifier, follow
these steps:
Step 1
Turn all of the equipment off and disconnect it from the power
source.
Step 2
Mount the DA AV EQ on a rack shelf, under a desktop or podium,
or through a desktop. See “Mounting the DA AV EQ Series” in
chapter 2, “Installation and Rear Panel,” for mounting procedures.
See “Optional Accessories” in appendix A, “Specifications, Parts,
and Accessories,” for part numbers.
Step 3
Wire the audio captive screw connectors. For the models with
captive screw connectors for audio input and output, follow the
illustrations below to wire them.
Unbalanced Stereo Input Balanced Stereo Input
Tip
Sleeve
Sleeve
Tip
LR LR Tip
Ring
Sleeves
Tip
Ring
Wiring the captive screw audio input connectors
For unbalanced audio, connect both sleeves
to the center contact ground. DO NOT connect
the sleeves to the negative (-) contacts.
CAUTION
Tip
Ring
Tip
Ring
LR
Sleeves
Unbalanced Output
Tip
Sleeves
Tip
LR
NO GROUND HERE
NO GROUND HERE
Balanced Output
Do not tin the wires!
Wiring the captive screw audio output
connectors
Disconnect all power to the unit before wiring.
This page was intentionally left blank.