The dfe-gold modules, The dfe-gold modules -2 – Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4H4284-49 User Manual

Page 22

Advertising
background image

The DFE-Gold Modules

1-2 Introduction

Support for a variety of converged applications including VoIP with Power‐over‐
Ethernet 

The DFE-Gold Modules

This section provides an overview of the 4H4282‐49, 4H4283‐49, 4H4203‐72 (

Figure 1‐1

), 

4H4202‐72, and 4H4284‐49 (

Figure 1‐2

) DFE‐Gold modules. 

The DFE‐Gold modules can be installed in a Matrix N1, N3, N5, N7, or E7 chassis.

The DFE‐Gold module ports can be configured to control traffic by limiting the rate of 
traffic accepted into the module and prioritizing traffic to expedite the flow of higher 
priority traffic through the module.

The DFE‐Gold module receives power and backplane connectivity when it is inserted into 
the chassis.

The information concerning how to configure the DFE module features are provided in 
the Enterasys Matrix DFE‐Gold Series Configuration Guide.

4H4282-49

The 4H4282‐49 is an edge‐network switch with 48, 10BASE‐T/100BASE‐TX compliant 
ports, through fixed front panel RJ45 connectors and an option slot for a network 
expansion module. Each of the fixed front panel ports can operate in either half‐duplex or 
full‐duplex mode of operation. The duplex mode can be determined by either auto‐
negotiation or manual configuration. 

4H4283-49

The 4H4283‐49 is an edge‐network switch with 48, 10BASE‐T/100BASE‐TX compliant 
ports through four fixed front‐panel RJ21 connectors and an option slot for a network 
expansion module. Each of the fixed front panel ports can operate in either half‐duplex or 
full‐duplex mode of operation. The duplex mode can be determined by either auto‐
negotiation or manual configuration. 

4H4203-72

The 4H4203‐72 has 72, 10BASE‐T/100BASE‐TX compliant ports through six front‐panel 
RJ21 connectors. Each of the fixed front panel ports can operate in either half‐duplex or 

Caution: Regardless of which chassis is used, the chassis system must be dedicated to
DFE-Gold modules (4xxxxx) only. Do not insert 7xxxxx modules or other legacy modules
into the same chassis with 4xxxxx modules as this will render the chassis inoperable.

Advertising
This manual is related to the following products: