Connecting to a vt series terminal, Connecting to a vt series terminal -22, Connecting an ibm pc or compatible -22 – Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4H4284-49 User Manual
Page 52: Вг б а
Connecting to COM Port for Local Management
3-22 Installation
Connecting to a VT Series Terminal
To connect a VT Series terminal to an Enterasys Networks DFE‐Gold module COM port
(
), use a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐DB25
female adapter, and proceed as follows:
1.
Connect the RJ45 connector at one end of the UTP straight‐through cable to the COM
port on the Enterasys Networks module.
2.
Plug the RJ45 connector at the other end of the UTP straight‐through cable into the
RJ45‐to‐DB25 female adapter.
3.
Connect the RJ45‐to‐DB25 adapter to the port labeled COMM on the VT terminal.
4.
Turn on the terminal and access the Setup Directory. Set the following parameters on
your terminal:
Figure 3-12 Connecting an IBM PC or Compatible
1 UTP straight-through cable with RJ45 connectors
3 RJ45-to-DB9 PC adapter
2 RJ45 COM port
4 IBM PC or compatible device
1X
RESET
COM
CPU
MGMT
GROUP
SELECT
GROUP
1
1
4H4282-49
FAST ENET
В
Г
Б
А
Parameter
Setting
Mode
7 Bit Control
Transmit
Transmit=9600
Bits Parity
8 Bits, No Parity
Stop Bit
1 Stop Bit