Something not working – Electrolux EDC47130W User Manual

Page 15

Advertising
background image

electrolux something not working 15

Something not working

Certain problems are due to lack of simple

maintenance or oversights, which can be

solved easily without calling out an engineer.

Before contacting your local Service Centre,

please carry out the checks listed below.
During machine operation it is possible that

the

red Start/Pause pilot light flashes to

indicate that the machine is not working.
Once the problem has been eliminated, press

the

Start/Pause button to restart the program.

If after all checks, the problem persists, contact

your local Service Centre.

Malfunction

Possible cause

Solution

Dryer does
not work

• Mains plug is not plugged in or fuse is not

working correctly

• Loading door is open
• Have you pressed the START/ PAUSE button?

• Plug in at mains socket

Check fuse in fuse box (domestic installation)

• Close loading door
• Press the START/PAUSE button again

Drying results
unsatisfactory

• Wrong program selected

• Lint filter clogged
• Condenser unit clogged with lint
• Incorrect load size
• Ventilation slots in base area covered up
• Residue on inside surface of drum or drum ribs

• Select a different program the next time

you use the dryer (see “Overview of
programs” section).

• Clean lint filter
• Clean condenser unit.
• Observe recommended loading volumes.
• Uncover ventilation slots in base area.
• Clean inside surface of drum and drum ribs

Loading door
does not close

• Fine strainer not in place and/or large mesh

filter not locked in place.

• Install fine strainer and/or snap large mesh

filter into place

When pressing
a button, the
corresponding
button flashes
several times.

• Washing protection

After the start of the program, the option can
no longer be set

• Turn the program knob to OFF.

Set the program again

Drying cycle
ends shortly
after program
starts. END
light illuminated

• Not enough washing loaded or washing

loaded is too dry for selected program.

• Select time program or higher drying level

(e.g. EXTRA DRY instead of CUPBOARD).

Program
inactive,

Water

tank full light
illuminated

• Water Tank is full

• Empty water tank, then start program

with START/PAUSE button.

Drying cycle
lasts an
unusually long
time.

Note: After
around 5 hours
the drying cycle
ends automatically
(see “Drying cycle
complete“)

• Lint filter clogged
• Condenser unit clogged with lint
• DELICATE button pressed and load volume

too big

• Load size too big
• Laundry insufficiently pre-drained

• Clean lint filter
• Clean condenser unit
• DELICATE is only suitable for use with loads

of up to 3 kg!

• Reduce load size
• Laundry must be sufficiently spun and/or

adequately pre-drained

EMAN_EDC4713OW_Feb09.indd 15

16/3/09 11:26:51 AM

Advertising