Empire Comfort Systems SR-18-3 - Manual (Page 11)

16942-3-0506 Page 11
On Solid Wall
1. After locating mounting holes, attach (4) #10 x 1" (25mm)
screws provided into the wall. Do not completely tighten
screwheads to the wall, leave a 1/8" (3mm) gap between
screwheads and wall.
2. Mount heater onto the (4) screwheads and complete tightening
screwheads into the wall.
Attention! Use the following steps to properly align the upper
louver and the reflector with the heat shield.
a. When replacing upper louver, be sure the bottom lip of
upper louver goes behind the heat shield.
b. When replacing reflector, be sure the top lip of reflector
goes in front of the heat shield.
3. Connect the gas line.
On Sheet Rock Wall
1. After locating mounting holes, drill (4) 5/16" (8mm) diameter
holes into the wall.
2. Insert (4) plastic expansion anchors provided into the holes.
3. Tighten (4) #10 x 1" (25mm) screws provided into the plastic
expansion anchors. Do not completely tighten screwheads to
the plastic expansion anchors, leave a 1/8" (3mm) gap between
screwheads and plastic expansion anchors.
4. Mount heater onto the (4) screwheads and complete tightening
the screwheads to the plastic expansion anchors.
Attention! Use the following steps to properly align the upper
louver and the reflector with the heat shield.
a. When replacing upper louver, be sure the bottom lip of
upper louver goes behind the heat shield.
b. When replacing reflector, be sure the top lip of reflector
goes in front of the heat shield.
5. Connect the gas line.
Figure 13
18”
(457mm)
14”
(356mm)
1 3/32”
(28mm)
18 7/8”
(479mm)
OUTLINE OF
OUTER CASING
22”
(559mm)
2 1/32” (52mm)
4 1/32” MIN
(102mm)
FLOOR
2” MIN (51mm)
MOUNTING HOLE LOCATIONS
VIEWED FROM FRONT OF HEATER
24 1/8”
(613mm)
20 1/8”
(511mm)
2”
(51)
2”
(51)
1 3/32”
(28mm)
18 7/8”
(479mm)
4 1/32”
(102mm)
MIN
2 1/32” (52mm)
22”
(559mm)
2” (51mm)MIN
Figure 11 (SR-18)
Figure 12 (SR-30)