Electrolux EEKG5048 - Manual (Page 33)

electrolux installation instructions 33
Fitting the stability bracket
It is recommended that if the appliance
is to be installed with a flexible supply
pipe, a stability bracket be fitted and is
available from your supplier (see
Important Safety Requirements). These
instructions should be read in
conjunction with any leaflet packed
with the stability bracket.
1. Place the appliance in its intended
position and level appliance.
2. Mark off 250mm from the left hand
side of the appliance as shown in
dimension 'A'. This is the centre line
of the fixing bracket.
478mm (B)
250mm
200mm
100mm
(A)
Stability
bracket
3. Draw a line 100mm from the front
edge of the feet and remove
appliance from its position. Mark off
dimension 'B' back from this line on
the centre line of the bracket to
locate the front edge of the lower
bracket. Fix lower bracket (with two
fixing holes) to the floor then
measure the height from floor level
to engagement edge on back of
appliance, dimension 'C'.
(C)
Stability
bracket
4. Assemble upper bracket to lower
bracket so that the underside of
bracket is dimension 'C' + 3mm
above floor level.
5. Reposition appliance and check
that top bracket engages into
appliance back as shown.
The battery
1.
The battery is located on the left
hand side of the front plinth.
2.
To gain assess to the battery, open
the main oven door and lift up the
battery holder lid.
3.
Fit the new battery ensuring (+)
terminal is next to the (+) sign on the
battery.